This page contains current and back issues of the Utah Woodchips newsletter; just click on the month you wish to read. Each issue issue contains the turning demonstration from the previous month.
2010
September	—Dave Best, Halloween bat houses (click here for part 2)
August	—Chris Pitlyk on hollow forms
July	—Kirk DeHeer turns threaded boxes
May	—Tom Sorenson, a candlabra
April	—Mike Swenson turns a natural-edge bowl
March	—Steve Howe turns a travel mug
February	—Mike Mahoney turns a set of nested bowls
January	—Dennis Brown does Harry Potter wands
2009
December	—Jay Brown presents Christmas gift ideas
November	—Joe Wagner on Christmas ornaments
October	—Bob Carter turns wedding goblets
September	—Exploding volcano shakers by Stuart Davey           Plus! John Kartchner on tapered rolling pins
August	—Tip-toe through the tulips with Larry Banz
July	—Mike Mahoney turns a calabash bowl
June	—Dave Best on salad and utility bowls
May	—Joe Wagner turns ducks off-center!
April	—John Kartchner turns square-bottomed boxes
March	—Paul Chilton demonstrates a platter
February	—Lane Phillips turns cut rings
January	—Bob Carter turns a French rolling pin
2008
December	—Doug Turner and his Rose Engine lathe
November	—Joe Wagner turns Christmas ornaments
October	—Chris Pytlik on turning dyed vessles
September	—Joe Wagner makes baby rattles
August	—Dave Best’s four best projects
July	—Kirk DeHeer on gouge grinds and cuts in bowls
June	—Dennis Brown turns a weed pot
May	—Paul Chilton demonstrates a peppermill
April	—Jay Brown on turning from small scraps
March	—Funeral urns by Mike Mahoney (and finishing)
February	—Dave Best turns stacked bowls
January	—Joe Wagner makes sewing thimbles   The AAW link mentioned in this issue: http://www.woodturner.org/info/news/letters/12_07_board_letter.html.
2007
December	—Doug Turner doughnut boxes
November	—Kip Christensen makes lighthouses
October	—Joe Wagner: acorn birdhouse ornaments
September	—Bob Carter turns a goblet
August	—Tommy Sorensen turns a three-legged milk stool
July	—Kirk DeHeer, square-edge bowls
June	—Joe Wagner, turned spatulas
May	—Lynn Jacobson, segmented turning
April	—Jim McBride, hand thread-chasing
March	—Mike Hyer, square-edged bowls
February	—Mike Mahoney, turning bowls and hollow forms
January	—Jerry Henson, turning pen and pencil sets
2006
December	—Bob Carter, layered bowls           Plus! American Woodturner article on layered bowls
November	—Jay Brown, captive rings and spalting
October	—Joe Wagner, Christmas ornements
September	—Dave Best on segmented turning
August	—Fancy lidded boxes by Dave Bouwhuis
July	—Dale Nish shows a hummingbird feeder
June	—Mark Shelton on texturing techniques
May	—Bruce Bassett on turning lace bobbins
April	—Bob Carter turns a wedding goblet with two captive rings
March	—Mike Mahoney sharpens gouges, turns bowls and a hollow form!
February	—Leonard Cleveland on turning a witch!
January	—Dave Best on segmented turning
2005
December	—Joe Wagner does Christmas ornements
November	—Rex Burningham on detailed bowl turning
October	—Dave Bouwhuis on small, lidded boxes
September	—Bob Whittaker on vases
August	—Bob Carter on rolling pins and oil lamps
July	—Alan Batty makes acorn boxes with threads
June	—Dennis Brown turns a bowl and a rattle           Plus! More on David Springett’s variety turning
May	—Bracelets by Joe Wagner           Plus! David Springett’s variety turning
April	—Hollow forms and finials by Thomas McCormick
March	—Lane Phillips and some don’ts of woodturning           Plus! David Springett’s woodturning wizardry
February	—Nut bowl by Bob Carter
January	—Christmas ornaments by Joe Wagner           Plus! Dave Smith’s Corner on “Alcohol soaking method for drying bowls” and The Mendenhall’s workshop
2004
December	—Assorted turnings by Kip Christensen
November	—Platters by Dave Anthony           Plus! Russ’ Corner on “Sanding” and Dennis Brown’s workshop
October	—Duck and goose calls by Kirk and Gary DeHeer
September	—Bird houses by Leonard Cleveland
August	—Volcano platter by Bob Carter           Plus! Leonard Cleveland’s workshop
July	—Spiral forms by Stuart Mortimer           Plus! Kurt DeHeer’s workshop
June	—A pepper mill with Kirk DeHeer
May	—Turning wooden instrument mouthpieces with Jerry Barfuss           Plus! Mike Swenson’s workshop
April	—Turning wooden instrument mouthpieces with Jerry Barfuss           Plus! Daryl Robbins’ workshop
March	—Precision turning technique with Stuart Batty           Plus! Stuart Davey’s workshop
February	—Deep bowls with Mike Mahoney           Plus! Bob Carter’s workshop
January	—Wooden ladle by Blaine Gardner
2003
December	—Birdhouse ornements by Dale Nish
November	—Miniatures by Stuart Davey
October	—Plates by Robert Fehlau
September	—Segmented turning by Kirt DeHeer
August	—Jameson tool hollowform by Dave Bouwhuis
July	—Bracelets by Raymond Mayo
June	—Inset lidded box by Stephen Hughes, coloring by Jimmy Clewes (unavailable)
May	—Candelabra by Tommy Sorensen (unavailable)
April	—Lidded bowl by Bob Carter
March	—Fluted leg shelf by Daryl Robbins
February	—Jameson laser tool by Mark Shelton
January	—Bowl saver by Ken Port, Australia